Sphaerococcus coronopifolius (Rhodophyta,Gigartinales): a Mediterranean red alga with potential and applications in restoration

Abstract

Experimental studies conducted on some species of Mediterranean red algae allowed to identify Sphaerococcus coronopifolius Stackhouse as a valid alternative to the Pacific alga Gloiopeltis furcata (Postels & Ruprecht) J. Agardh, for the extraction of a material usable as natural consolidant and adhesive in the field of restoration. Promising results have been observed by comparing the extracts obtained from these two algae after the same extraction procedure. Chemical analysis (FTIR) revealed that S. coronopifolius has qualities similar to G. furcata. Even more promising results for S. coronopifolius compared to G. furcata were observed after the analysis of pH and conductivity, and the adhesion tests carried out on both extracts.     

Carbon Paste Composite with Co3O4 as a New Electrochemical Sensor for the Detection of Allura Red by Reduction

The detection of Allura red (AR) by electrochemical reduction using a different electrode from the conventional mercury electrode is presented. A carbon paste with cobalt (II, III) oxide composite electrode (CoO_x/CPE) is reported for the first time for the detection of AR. Moreover, others dyes such as tartrazine (TZ), sunset yellow (SY), amaranth (AM), Ponceaut 4‐R (P‐4R), and Sudan (SD) as well as pharmaceutical agents such as paracetamol (PMC) that are present in samples that contained AR did not show a reduced signal between 0.0 and ?0.3 V, which is the potential range where AR reduction was observed. The surface electroactivity was studied using cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and scanning electron microscopy (SEM). The presence of CoO_X increased the cathodic peak current for AR by more than 50 % and 65 % via CV and square wave voltammetry (SWV), respectively, compared with an unmodified carbon paste electrode. Under the optimal parameters, (pH=3.0, accumulation time (t_ACC)=60 s and accumulation potential (E_ACC)=0.50 V), the detection limit for AR was 0.05 μmol L^?1. The new sensor was sensitive and stable for the detection of AR. Moreover, it was easily manufactured and very convenient for food samples such as soft and isotonic drinks as well as chili sauce.     

13.56 MHz/2 MHz柱状感性耦合等离子体参数的对比研究

通过Langmuir双探针和发射光谱诊断方法,对比研究了驱动频率为13.56 MHz和2 MHz柱状感性耦合等离子体中电子密度和电子温度的径向分布规律.结果表明:在高频和低频放电中,输入功率的增加对等离子体参数产生了不同的影响,高频放电中主要提升了电子密度,低频放电中则主要提升了电子温度.固定气压为10 Pa,分别由高频和低频驱动时,电子密度的径向分布均为"凸型".而电子温度的分布差异比较明显,高频驱动时,电子温度在腔室中心较为平坦,在边缘略有上升;低频驱动时,电子温度随径向距离的增加而逐渐下降.为了进一步分析造成这种差异的原因,在相同放电条件下采集了氩等离子体的发射光谱图,利用分支比法计算了亚稳态粒子的数密度,发现电子温度的径向分布始终与亚稳态粒子的径向分布相反.继续升高气压到100 Pa,发现不论高频还是低频放电,电子密度的径向分布均从"凸型"转变为"马鞍形",较低气压时电子密度的均匀性有了一定的提升,但低频的均匀性更好.     

Exploring Potential Energy Surfaces for Aggregation‐Induced Emission—From Solution to Crystal

Aggregation‐induced emission (AIE) is a phenomenon where non‐luminescent compounds in solution become strongly luminescent in aggregate and solid phase. It provides a fertile ground for luminescent applications that has rapidly developed in the last 15 years. In this review, we focus on the contributions of theory and computations to understanding the molecular mechanism behind it. Starting from initial models, such as restriction of intramolecular rotations (RIR), and the calculation of non‐radiative rates with Fermi's golden rule (FGR), we center on studies of the global excited‐state potential energy surfaces that have provided the basis for the restricted access to a conical intersection (RACI) model. In this model, which has been shown to apply for a diverse group of AIEgens, the lack of fluorescence in solution comes from radiationless decay at a CI in solution that is hindered in the aggregate state. We also highlight how intermolecular interactions modulate the photophysics in the aggregate phase, in terms of fluorescence quantum yield and emission color.     

Engineering nanostructures of CuO-based photocatalysts for water treatment: Current progress and future challenges

Nowadays, increasing extortions regarding environmental problems and energy scarcity have stuck the development and endurance of human society. The issue of inorganic and organic pollutants that exist in water from agricultural, domestic, and industrial activities has directed the development of advanced technologies to address the challenges of water scarcity efficiently. To solve this major issue, various scientists and researchers are looking for novel and effective technologies that can efficiently remove pollutants from wastewater. Nanoscale metal oxide materials have been proposed due to their distinctive size, physical and chemical properties along with promising applications. Cupric Oxide (CuO) is one of the most commonly used benchmark photocatalysts in photodegradation owing to the fact that they are cost-effective, non-toxic, and more efficient in absorption across a significant fraction of solar spectrum. In this review, we have summarized synthetic strategies of CuO fabrication, modification methods with applications for water treatment purposes. Moreover, an elaborative discussion on feasible strategies includes; binary and ternary heterojunction formation, Z-scheme based photocatalytic system, incorporation of rare earth/transition metal ions as dopants, and carbonaceous materials serving as a support system. The mechanistic insight inferring photo-induced charge separation and transfer, the functional reactive radical species involved in a photocatalytic reaction, have been successfully featured and examined. Finally, a conclusive remark regarding current studies and unresolved challenges related to CuO are put forth for future perspectives.     

Efficient structural modification of electron-withdrawing substituents on Pt(II) complexes for red emitters: A theoretical study

In this study, the electronic structures and optical properties of a cyclometalated Pt(II) complex (M1) and a series of derivatives (M1–F, M1–CF₃, and M1–CN) with electron-withdrawing substituents (–F, –CF₃, and –CN) at the carbazole moiety were theoretically investigated by density functional theory and time-dependent density functional theory. The calculation results reveal that these Pt complexes display deep red phosphorescence emission above Λ = 640 nm. When the ³MLCT/π → π* to triplet metal-centered ³MC/d–d state decay mechanism is taken into consideration, the nonradiative decay rate constant (k_nr) decreased in the order M1 > M1–CF₃ > M1–F > M1–CN. The <T₁|H_SOC|S_m> and kr values of M1-F are similar with those of M1, however the Knr rate ofM1-F is larger than that of M1. M1–F is expected to have improved quantum yields. Moreover, through the analyses of the HOMO/LUMO level and triplet energy, it is found that the introduction of –F and –CN substituents in M1 results in efficient energy transfer from the host material 4,4′-N,N′-dicarbazole-biphenyl to these complexes. In view of the electroluminescent applications in organic light-emitting diodes, M1–F can serve as efficient deep-red guest materials with improved electron injection and transport ability.     

Synthesis of alkyl-H-phosphinic acid alkyl esters from red phosphorus and alkyl bromides

Alkyl-H-phosphinic acid alkyl esters are synthesized in 65–71% yield via chemoselective reaction of alkyl bromides with available alkyl-H-phosphinic acids (60–65 °C, Et3N). The latter are prepared, in turn, by direct phosphorylation of alkyl bromides with red phosphorus under phase-transfer conditions.     

Aggregation-Induced Generation of Reactive Oxygen Species: Mechanism and Photosensitizer Construction

Luminogens with aggregation-induced emission (AIEgens) have been widely applied in the field of photodynamic therapy. Among them, aggregation-induced emission photosensitizers (AIE–PSs) are demonstrated with high capability in fluorescence and photoacoustic bimodal imaging, as well as in fluorescence imaging-guided photodynamic therapy. They not only improve diagnosis accuracy but also provide an efficient theranostic platform to accelerate preclinical translation as well. In this short review, we divide AIE–PSs into three categories. Through the analysis of such classification and construction methods, it will be helpful for scientists to further develop various types of AIE–PSs with superior performance.     

Photoluminescence of green nanophosphors Sr2MgSi2O7 doped with Tb3+ under 374-nm excitation

A series of Sr₂MgSi₂O₇:Tb³⁺ nanophosphors is prepared using a high-temperature solid-state reaction. The x-ray diffraction patterns show that the crystal structure of the sample is not significantly affected by Tb³⁺ ions. However, the images of the scanning electron microscope illustrate that the average size of nanoparticles becomes larger with the increase of Tb³⁺ concentration. Unlike earlier investigations on down-conversion emission of Tb³⁺ ion excited by deep ultraviolet light, in this work, the photoluminescence characteristics of Sr₂MgSi₂O₇ nanophosphors doped with different Tb³⁺ concentrations are analyzed under 374-nm excitations. The intense green emission at 545 nm is observed at an optimal doping concentration of 1.6 mol%. The main reason for the concentration quenching is due to the electric dipole-electric dipole interaction among Tb³⁺ ions.